A tough, slip resistant coating to freshen up dull, gray asphalt and concrete. Anti-Slip Traffic Paint is an excellent UV resistant coating with a textured surface to offer slip resistance to pedestrians. It can be used for both interior and exterior applications even on damp surfaces. Anti-Slip Traffic Paint is the ideal coating for the following applications: to highlight external walkways, parking lot spaces and markings, identify safe or hazardous pedestrian and vehicle areas using color codes.

Features and Benefits of Anti-Slip Traffic Paint - Anti-slip Floor Coating:

A tough, slip-resistant coating to freshen up dull, gray asphalt and concrete

Excellent resistance to UV

Textured surface offers slip resistance for pedestrians

Can be applied to damp surfaces

Suitable for asphalt and concrete surfaces

Covers approximately 120 - 160 sq.ft. per gallon

Ready for traffic in 24 hours at 60-70°F

Surface Preparation: Anti-Slip Traffic Paint can be applied to asphalt, tarmac and porous concrete. Ensure the surface is clean, sound and dry (slightly damp is acceptable). Clean substrate with a biodegradable solvent free degreaser which can be used on asphalt and similar surfaces. Anti-Slip Traffic Paint can be applied to existing paint provided all poorly bonded material is removed and glossy surfaces are dulled by scuff-sanding with an abrasive paper.

Application: Apply Anti-Slip Traffic Paint by brush, 3/8" nap roller or with our 18" roller frame and handle. One coat is generally sufficient although a second coat may be required on very porous or rough surfaces. Avoid applying too thickly. The fine texture may not be immediately apparent when the product is first applied. The texture develops further as the paint dries. Do not apply externally if rain or frost is forecasted or if the temperature is below 50°F. The second coat should be applied after 1 hour. In extreme temperature conditions, please contact a Rust-Oleum Industrial Flooring Expert at (855) 627-6350.

Curing Time: The product will cure sufficiently in 24 hours for light traffic; allow 48 hours before bringing the area back into full service. Cold, damp or humid weather will delay curing.

Coverage: One gallon covers approximately 120-160 sq ft depending on the texture of the substrate. One coat normally required. Do not use the paint to fill the texture of open tarmac or asphalt surfaces. This will reduce the coverage rate and extend the drying time of the paint. It could also reduce the ability of asphalt to drain which may lead to slip problems in wet areas.